not sure if this video is recently filmed but i do hvac work for a living
and if the unit heater has copper tubes in it i peel away the fins where it
is leaking and braze it with with silfloss (the brazing rod used for
refrigerant lines) if you dont have an oxy/acetelyne torch map gas will get
hot enough to braze it also modine will sell you a new coil for it still
cheaper than a new unit.
Cut a piece of inch thick board 20×17. From the 17″ edge attach an 8″ piece
of 3×2. 7″ from the opposite edge attach a 13″ piece of 3×2. Clamp this
into the Jaw Horse for a machine table etc.
Rock on, Adam! Ive been watching your build now for about 6 months and you
have done an amazing job on that garage and all the other projects that
came along with it. Ya get a bum deal every now and then. No biggie. The
hard work you put into it will pay dividends some day. Keep up the great
work!
Bummer!
keep your chin up im sure you will find another or work it out dude!! great
video
not sure if this video is recently filmed but i do hvac work for a living
and if the unit heater has copper tubes in it i peel away the fins where it
is leaking and braze it with with silfloss (the brazing rod used for
refrigerant lines) if you dont have an oxy/acetelyne torch map gas will get
hot enough to braze it also modine will sell you a new coil for it still
cheaper than a new unit.
Cut a piece of inch thick board 20×17. From the 17″ edge attach an 8″ piece
of 3×2. 7″ from the opposite edge attach a 13″ piece of 3×2. Clamp this
into the Jaw Horse for a machine table etc.
Rock on, Adam! Ive been watching your build now for about 6 months and you
have done an amazing job on that garage and all the other projects that
came along with it. Ya get a bum deal every now and then. No biggie. The
hard work you put into it will pay dividends some day. Keep up the great
work!
Keep a bucket under it. You’ll be fine.